stringer (support board) on the wall studs at the recommended height for the tub lip to rest on.7. Place the tub in position. Use a level on the tub rim to ensure it is perfectly level side-to-side and front-to-back.8. Mark Studs: Mark the tub flange on the wall studs to identify where to screw it down.9. Remove the Tub: Take the tub back out.10. Install Mortar Bed: Place a bed of mortar or structural foam under the tub base. This provides crucial support and prevents flexing.11. Set the Tub: Carefully place the tub back onto the mortar bed, pushing it firmly into the stringer.12. Re-Level: Immediately check that the tub is still level.13. Secure to Studs: Drill pilot holes through the flange (if not pre-drilled) and fasten the tub to the studs using galvanized screws or nails.14. Connect the Drain: Connect the drain assembly to the waste line beneath the floor.15. Install Faucet/Valve: Install the shower faucet and drain handle.16. Test for Leaks: Close the drain, fill the tub, and check all plumbing connections for leaks.17. Install Wall Board: Install cement board or waterproof backer board, overlapping the tub flange.18. Seal the Flange: Apply a bead of silicone caulk between the tub flange and wall studs.19. Waterproofing: Apply waterproofing membrane (e.g., RedGard) over the cement board.20. Tiling: Install wall tile or surround.21. Final Sealing: Apply silicone sealant along the joint where the tile meets the bathtub ledge.22. Final Test: Allow the sealant to cure, then test again. To help you better, could you confirm if this is a: Drop-in tub? Alcove tub with a flange? Freestanding tub?
Installing a portable tub usually takes less than 10 minutes and requires no permanent plumbing. 1. Prepare the Area ashhbritt101 bathtub 22l install
Inside a walk-in shower stall is the gold standard. If that’s not possible, choose a flat, smooth area within 3 feet of a floor drain or an exterior door (to drain outside). Mark the tub’s outline with painter’s tape. stringer (support board) on the wall studs at
Check if the floor is stable and level; mark your reference lines on the wall studs. Drain Assembly: Connect the drain and overflow assembly to the tub setting it into its final place for the easiest access. Leak Testing: Mark Studs: Mark the tub flange on the