Decastar 150e - Manual

Decastar 150e MIG Welder Manual | PDF | Electricity - Scribd

| Terminal | Signal | |----------|--------| | +10V / +24V | Reference voltage for potentiometer/sensors | | AI1 | Analog input (0–10V or 4–20 mA) | | AI2 | Secondary analog input (e.g., feedback) | | DI1–DI4 | Digital inputs (start/stop, reverse, multi-speed) | | DO1 | Digital output (fault, speed reached) | | AO1 | Analog output (0–10V for frequency meter) | | COM | Common ground | decastar 150e manual

Set P.09 = 1 . The indicator will stream weight data 10 times per second. Decastar 150e MIG Welder Manual | PDF |

| Error | Meaning | Solution (from manual) | |-------|---------|------------------------| | | EEPROM failure | Replace mainboard. Attempt reset via r.St in Tech Menu. | | ERR03 | A/D converter not responding | Check power supply (minimum 12V DC). Check internal ribbon cable. | | ERR05 | Weight exceeds max + 9d | Remove load. Check for mechanical binding. | | ERR08 | Underload (negative overload) | Calibration zero lost. Perform C.IN again. Check load cell wiring (Excitation +/-). | | ERR31 | Calibration weight error | Applied weight < 1% of full scale. Use larger test weight. | | Lo BAT | Low battery (if backup option fitted) | Replace internal battery or connect mains. | Attempt reset via r

. This information is often found on a diagram inside the lid of the machine. Wire Thickness: It typically supports 0.6mm to 0.8mm wire. Technical Specifications Specification Input Voltage 230V (Single Phase) Welding Current 30A – 145A Duty Cycle Common Issues: