Gateman+v20+manual -

Enter your desired 4 to 12-digit password on the exterior keypad. button again to complete the registration. Registering Key Tags button inside the battery cover. Touch each new key tag to the external card reader one by one. button again to finish. Auto/Manual Locking Mode A/M switch under the battery cover. : The door locks automatically a few seconds after closing. Manual Mode

The manual has a specific sequence to change how the lock behaves. gateman+v20+manual

The lock sensor detects the door closing and engages the bolt within 5 seconds. Enter your desired 4 to 12-digit password on

: In the event of a fire, the lock detects high heat from the inside, triggers an alarm, and automatically unlocks to allow for a quick exit. Touch each new key tag to the external

If the batteries die completely, hold a 9V battery against the emergency contact points at the bottom of the external unit. While holding the battery in place, enter your PIN or use your key tag to unlock the door. 5. Troubleshooting Common Issues Potential Cause Keypad doesn't light up Dead batteries or loose connection Check batteries or use a 9V emergency battery. "Beep beep" error sound Door not closed properly Ensure the strike plate and deadbolt are aligned. PIN code not working Wrong code or "Force Lock" active Check if Privacy Mode was set from the inside. Card not reading Unregistered card Re-register the card using the (I) button. 6. Safety Precautions