⚠️ Do not exceed 12V. Do not power high-current motors (>700mA) from Arduino’s 5V pin.
We have consolidated the missing HW-130 specific data—pin mapping, power jumper configuration, and board-level restrictions—into this article. Consider this your . hw 130 motor control shield for arduino datasheet free
for 5V "hobby" servos, connected to the Arduino’s high-resolution timers for jitter-free control. Power Handling Voltage Range : Supports motors from 4.5V to 25V DC (some variants up to 36V). Current Output : Provides 0.6A per bridge (1.2A peak) with internal thermal shutdown protection. Logic Isolation : A 2-pin terminal block and jumper allow for separate power supplies ⚠️ Do not exceed 12V
The is a low-cost, compact motor driver shield designed for Arduino Uno (and compatible) boards. It allows the control of two DC motors (bidirectional) or one stepper motor. The shield is based on the L9110S (or equivalent MX1508) H-bridge driver IC, known for its low saturation voltage and internal protection diodes. Consider this your