Xerox Fault Code 043-343 Upd -

Often, this is simply a timing error that can be cleared with a full power drain.

Open or short circuits in the wiring between the sensor, solenoid, and the Drive PWB (Printed Wire Board). PWB Faults: Xerox Fault Code 043-343

: The Motor Driver Board (MCU) is failing to send signals. Often, this is simply a timing error that

If you have performed the steps above and the error persists, a hardware component has likely failed. This error typically requires a technician to replace one of the following parts: Xerox Fault Code 043-343

: Technicians use the dC330 diagnostic mode (code 042-011) to initialize the First Bias Transfer Roller (1st BTR) and observe if the link bar moves. Hardware Inspection :

Repair and parts considerations